: Create a project in STM32CubeIDE . For a standard "Hello World" blinky, configure a GPIO pin (e.g., PA5 ) as an output and build the project to generate a .hex file. Load into SimulIDE : Right-click the STM32 component in SimulIDE. Select Load Firmware and navigate to your .hex file.
: Use the Serial Monitor component to debug UART data sent from the STM32 to a virtual terminal. simulide stm32 full
If you’d like, I can:
: Use the Monitor tool in SimulIDE to watch registers and RAM in real-time while your simulation is running. : Create a project in STM32CubeIDE